[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
Re: (erielack) CWR - made in Salamanca
- Subject: Re: (erielack) CWR - made in Salamanca
- From: Smtimko_@_aol.com
- Date: Sun, 15 Oct 2006 16:28:26 EDT
In a message dated 10/15/2006 11:02:29 A.M. Eastern Daylight Time,
schuyler.larrabee_@_verizon.net writes:
So, do these pull-aparts happen at the welded joint? Always? Or are there
other breaks at faults in
the rail?
SGL
Usually you don't get pull-aparts in welded rail. If a weld is going to
break, it will usually fail within a few months of installation, no matter what
the temperature is.
Welded rail usually just breaks due to a combination of tension, cold snaps
and a weak spot in the rail. It is not unusual to see this happen but it is
much less frequent than a pull-apart in jointed rail.
SMT
The Erie Lackawanna Mailing List
Sponsored by the ELH&TS
http://www.elhts.org
------------------------------